Model: DPL700

  1. Insert one AA battery into the PhotoTrackr.
  2. Press and hold the On/Off Button to turn on the GPS PhotoTrackr device. (Light 3 will flashing in orange indicating device is turned on.)
  3. When GPS signal is fixed, Light 1 will flash in green.
  4. When the battery is low, Light 2 will flash in red.
  5. Light 3 will flash in orange when the device is connected to a computer.
  6. Light 2 will flash in red during GPS data downloads.
  7. To tag a waypoint, press the On/Off Button once during trip recording.

Model: CD111/CD110BT

6
  1. Please charge the GPS PhotoTrackr unit at least three hours before use. (Button 2 will flash in green when charging, it will stop flashing when the unit is fully charged.)
  2. Press and hold Button 2 to turn on the GPS PhotoTrackr device.
  3. Press Button 1 to increase the speaker volume; Press Button 3 to decrease.
  4. When GPS signal is fixed, Button 1 will flash in red.
  5. Press and hold Button 1 and Button 3 to disable the LED (stealth mode). Press both buttons again to enable LED.
  6. Press and hold Button 1 and Button 2 to hear the GPS time in 24 hour standard according to the initial setup time zone. (e.g. 2:15 pm will be announced as 1-4-1-5) * time zone value will be set when the logger is connected to the computer and its settings are being saved for the first time. The time announcement function will not be activated until the time zone is set.
  7. (For CD110BT only) Press button 2 to enable/disable the Bluetooth function. (Note: Bluetooth Paring Code is 0000)
  8. Waypoint Tagging Mode: press and hold button 1 to tag a waypoint.
  9. Trip Tagging Mode: press and hold button 1 to start a trip, press and hold button 1 again to end a trip.
  10. User Adjustable: press and hold button 3 to switch between Waypoint Tagging Mode and Trip Tagging Mode.