GPS Hardware Overview

PhotoTrackr Mini DPL900 Hardware Operation

• If this is your first time using PhotoTrackr Mini, please refer to Quick Start Guide (Windows|Mac).
• Status LED:
• When GPS is fixed, LED will flash.
• When a waypoint is tagged, LED will flash rapidly
• When device is turned on and is searching for GPS, LED will stay solid
• Waypoint Button: in order to tag a waypoint, press and hold the button for 2 seconds until the Status LED flashes rapidly
• USB Connection: device needs to be turned on before connecting to PC

PhotoTrackr Lite DPL700 Hardware Operation

• If this is your first time using PhotoTrackr Lite, please refer to Quick Start Guide (Windows|Mac).
• Insert one AA battery into the PhotoTrackr.
• Press and hold the On/Off Button to turn on the device. (LED #1 will flashing in orange indicating device is turned on.)
• When GPS signal is fixed, LED #3 will flash in green.
• When the battery is low, LED #2 will flash in red.
• LED #1 will flash in orange when the device is connected to a computer.
• LED #2 will flash in red during GPS data downloads.
• To tag a waypoint, press the On/Off Button once during trip recording.

PhotoTrackr CD111/CD110BT Hardware Operation

• If this is your first time using PhotoTrackr, please refer to Quick Start Guide (Windows|Mac).
• A full charge will take about two hours. (Button 2 will flash in green when charging.)
• Press and hold Button 2 to turn on the GPS PhotoTrackr device.
• Press Button 1 to increase the speaker volume; Press Button 3 to decrease.
• When GPS signal is fixed, Button 1 will flash in red.
• Press and hold Button 1 and Button 3 to disable the LED (stealth mode). Press both buttons again to enable LED.
• Press and hold Button 1 and Button 2 to hear the GPS time in 24 hour standard according to the initial setup time zone. (e.g. 2:15 pm will be announced as 1-4-1-5) * time zone value will be set when the logger is connected to the computer and its settings are being saved for the first time. The time announcement function will not be activated until the time zone is set.
• (For CD110BT only) Press button 2 to enable/disable the Bluetooth function. (Note: Bluetooth Paring Code is 0000)
• Waypoint Tagging Mode: press and hold button 1 to tag a waypoint.